I recently acquired a beautifully figured piece of Douglas Fir (or I think it's Douglas Fir. I live on the east coast of N.A. and would never have seen any before). Rough measurements are 40"x11"x1.25". When I found the wood, it was painted on both sides. Looking at the end grain, it looked plain sawn. When I ran it through a planer, I was surprised to see the beautiful grain structure. I know it would make a beautiful electric, but wondering if it's out of the question to consider it for an acoustic top... And yes, I know it's not quarter sawn...
Just looking for ideas and suggestions...
Douglas Fir - looking for ideas...
Douglas Fir - looking for ideas...
- Attachments
-
- 294354946_10160516058231393_1890044224828009786_n.jpg (200.56 KiB) Viewed 707 times
Last edited by gilles on Sun Jul 24, 2022 6:43 am, edited 1 time in total.
Re: Douglas Fir - looking for ideas...
End grain...
- Attachments
-
- 293640762_10160516273866393_2638506884209278040_n.jpg (139.75 KiB) Viewed 694 times
Re: Douglas Fir - looking for ideas...
Jee, Gilles. I would say, for a solid body great. For an acoustic I would pass. That wild flat sawn wood will act unpredictible to changes in temperature and humidity IMO.
Herman
Herman
-
peter havriluk
- Posts: 958
- Joined: Sun Jul 29, 2012 12:30 pm
- Location: Granby, CT
-
K Wiebusch
- Posts: 84
- Joined: Wed Mar 06, 2019 11:39 pm
- Location: Southeast Texas
Re: Douglas Fir - looking for ideas...
I would have to resaw it and make a four piece top. That grain is incredible! I built a 00 12 fret out of fir. It is a great top wood.